pfsense:install_pfsense:installation_of_pfsense:connect_using_a_console_cable
This is an old revision of the document!
Table of Contents
PFSense - Install pfSense - Installation of pfSense - Connect using a Console Cable
Using a Serial Cable (optional)
Connect the console cable to the router.
Make sure that your tty device shows up in /dev.
- If you have a USB cable, you should see /dev/ttyUSB0.
- If you have a regular cable you should see /dev/ttyS0.
Verify:
ls /dev/ttyUSB0
returns:
/dev/ttyUSB0
The same instructions would apply for /dev/ttyS0 if you used that type of cable instead of a USB console cable.
NOTE: If you are using Windows, your Serial port will simply be called COM1.
Connect using Putty.
Make sure you have putty installed, and start it as root:
sudo putty
- Serial line: /dev/ttyUSB0. or ttyS0 if not using a USB console cable.
- Connection type: Serial.
- Speed: 115200.
NOTE: If you use Windows, launch putty with administrative privileges.
Click open and your session should start.
NOTE: You may need to go into the BIOS of the router to allow it to boot up from the USB.
You also may need to press a key, such as F10 to make sure your USB stick has been detected.
pfsense/install_pfsense/installation_of_pfsense/connect_using_a_console_cable.1606919564.txt.gz · Last modified: 2020/12/02 14:32 by peter