Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Ubuntu - Samba - Resolve rlimit_max below minimum Windows limit ======

Running the **testparm** command, which checks the Samba config file for errors, sometimes shows a message:

<code bash>
rlimit_max: increasing rlimit_max (1024) to minimum Windows limit (16384)
</code>

<WRAP info>
**NOTE:**  This is just a warning.

  * On MS Windows the number of file handlers on the client and the server must be identical, else you will see the "too many files open" message when e. g. copying files over the network.
  * More recent Samba versions take care of this on their own.
  * However, if you want to remove this warning, you can do so by changing your local file limits.
  * It is always useful to distinguish local (user or session) limits and global (system wide) limits. 

</WRAP>

----

===== Check you global limits =====

<code bash>
cat /proc/sys/fs/file-max
</code>

result:

<code bash>
3271317
</code>

<WRAP info>
**NOTE:**  Chances are good that your global limits far exceed your local limits.

  * The typical GNU/Linux limit is in the 100k range.
  * You can change this value temporarily by executing:

<code bash>
sysctl -w fs.file-max=n
</code>

or permanently by editing **/etc/sysctl.conf** and running **sysctl -p**.

</WRAP>

----

===== Check local limits =====

<WRAP info>
**NOTE**:  Run these commands as the user which is running Samba.
</WRAP>

Hard limits are enforced by the system:

To check the hard limits:

<code bash>
ulimit -Hn
</code>

result:

<code bash>
65536
</code>

----

===== To check the soft limits =====

<code bash>
ulimit -Sn
</code>

result:

<code bash>
1024
</code>

<WRAP info>
**NOTE:**  This will show you hard and soft limits for the local session.

  * The hard limit is enforced by the system, while the soft limit is enforced by the local session.
  * You can increase the local soft limit up to the global hard limit, if necessary.

</WRAP>

----

===== Temporarily change limits =====

You can change the limits temporarily by running:

<code bash>
ulimit -Hn n
ulimit -Sn m
</code>

or you can set user limits via **/etc/security/limits.conf** and you can even specify for which users which limits apply, e. g.

<file bash /etc/security/limits.conf>
samba soft nofile 16384
samba hard nofile 32768
</file>

<WRAP info>
**NOTE:**  The man-pages of both files and the commands offer much more insight.
</WRAP>