Differences

This shows you the differences between two versions of the page.

--- ubuntu:openssl:encrypt_a_file [2021/01/29 16:15] – peter
+++ ubuntu:openssl:encrypt_a_file [2021/01/30 18:34] (current) – [Encrypt (interactive)] peter
@@ Line 70: / Line 70: @@
 <WRAP info>
 **NOTE:**  The **-salt** option should ALWAYS be used if the key is being derived from a password.
+Without the **-salt** option it is possible to perform efficient dictionary attacks on the password and to attack stream cipher encrypted data.
+The reason for this is that without the salt the same password always generates the same encryption key.
+When the salt is being used the first eight bytes of the encrypted data are reserved for the salt: it is generated at random when encrypting a file and read from the encrypted file when it is decrypted.
 </WRAP>
+----
+===== Decode a file that was encrypted using aes256 =====
+<code bash>
+openssl enc -aes256 -d -in test1.enc -out test2.txt
+</code>
+----
+===== Encrypt using base64 =====
+<code bash>
+openssl enc -aes256 -a -e -salt -in test1.txt -out test1.enc
+</code>
+<WRAP info>
+**NOTE:**  Same as for standard encoding, but with the **-a** option.
+</WRAP>
+----
+===== Decrypt a file that was encrypted using base64 =====
+<code bash>
+openssl enc -aes256 -d -in test1.enc -out test2.txt
+</code>
+<WRAP info>
+**NOTE:**  Same as for standard base decoding, but with the **-a** option.
+</WRAP>
+----
+===== Encrypt (interactive) =====
+<code bash>
+openssl enc -aes-256-cbc -in file.txt.enc -out file.txt  -iter 29 -k PASS
+</code>
+<WRAP info>
+**NOTE:**  The iteration count is for the PBKDF2 hashing algorithm that is designed to make password cracking much much harder.
+Using a low iteration count like 29 is not very useful.
+The count should be made as large as you can without it becoming too annoying (1 to 2 seconds of iteration).
+The current default of 10000 is var too low, even when it was released!  500000 or higher is better.
+</WRAP>
+----
+===== Decrypt (interactive) =====
+<code bash>
+openssl enc -aes-256-cbc -d -in file.txt.enc -out file.txt -iter 29 -k PASS
+</code>
+----
+===== Encrypt (non-interactive) =====
+<code bash>
+openssl enc -aes-256-cbc -in file.txt.enc -out file.txt  -iter 29 -pass pass:mysecret
+</code>
+----
+===== Decrypt (non-interactive) =====
+<code bash>
+openssl enc -aes-256-cbc -d -in file.txt.enc -out file.txt -iter 29 -pass pass:mysecret
+</code>