Differences

This shows you the differences between two versions of the page.

--- ubuntu:gpu:amd_gpu:overclocking:increase_power_on_amd_gpus [2023/06/27 13:28] – peter
+++ ubuntu:gpu:amd_gpu:overclocking:increase_power_on_amd_gpus [2023/06/27 13:45] (current) – [Set the Voltage] peter
@@ Line 162: / Line 162: @@
 ===== Set the Voltage =====
+<WRAP info>
+**NOTE:**  P-states (Power States) are levels, L0 to L7. that indicate the frequency and voltage of the GPU processor at that state.
+  * P0 is the lowest, when the system is idle, as normally do not need higher voltage and frequency.
+  * P6/P7 are what are used when gaming,
+  * P7 is the highest, when very heavy GPU usage is used.
+    * But note that P7 uses more voltage and higher frequency; which results in more heat.
+    * Often P7 is not needed.
+</WRAP>
 To edit the P-state #7 for the core and #2 for the VRAM, as those are the values that our GPU is going to run at while under load.
@@ Line 182: / Line 193: @@
 ----
+===== Apply the changes =====
 <WRAP alert>
 **WARNING:** Double check the entered values, as mistakes might instantly cause fatal hardware damage!
 </WRAP>
-To apply, run:
 <code bash>