ubiquiti:wifi:channel_width
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| ubiquiti:wifi:channel_width [2023/11/21 12:14] – peter | ubiquiti:wifi:channel_width [2023/11/21 12:17] (current) – peter | ||
|---|---|---|---|
| Line 9: | Line 9: | ||
| ===== Recommendation ===== | ===== Recommendation ===== | ||
| - | * **2.4 GHz** should almost always be set to 20 MHz. | + | * **2.4 GHz**: Always |
| * There is not enough space in the 2.4 GHz spectrum to reliably use 40 MHz channels, especially with multiple APs. | * There is not enough space in the 2.4 GHz spectrum to reliably use 40 MHz channels, especially with multiple APs. | ||
| - | * **5 GHz** can be set to 20, 40, 80, or 160 MHz. | + | * **5 GHz**: Set to 20, 40, 80, or 160 MHz. |
| * A higher setting value will provide a higher throughput. | * A higher setting value will provide a higher throughput. | ||
| - | * Some clients may not fully support 160 MHz channels in 5 GHz, which requires DFS. | + | * Some clients may not fully support 160 MHz channels in 5 GHz, which requires DFS (Dynamic frequency selection). |
| * A lower setting value will support higher client density. | * A lower setting value will support higher client density. | ||
| - | * **6 GHz** can safely be set to 80 or 160 MHz. | + | * **6 GHz**: Set to 80 or 160 MHz. |
| * There is a lot of available spectrum for wide channels, and no requirement for DFS (Dynamic frequency selection) or AFC (Automated Frequency Coordination). | * There is a lot of available spectrum for wide channels, and no requirement for DFS (Dynamic frequency selection) or AFC (Automated Frequency Coordination). | ||
| + | |||
| + | |||
ubiquiti/wifi/channel_width.1700568886.txt.gz · Last modified: 2023/11/21 12:14 by peter