Differences

This shows you the differences between two versions of the page.

--- ubiquiti:cli:cheat_sheet [2022/10/11 09:59] – peter
+++ ubiquiti:cli:cheat_sheet [2022/10/11 10:07] (current) – peter
@@ Line 1: / Line 1: @@
 ====== Ubiquiti - CLI - Cheat Sheet ======
+Unifi devices are running on a form of Linux, so most Linux commands will work on the devices.
+  * Pressing **Tab** twice will give you a list of all available SSH commands.
 Commands that can be run on Unifi devices from the command line.
@@ Line 11: / Line 15: @@
 |set-inform <inform_url>|Set URL of the controller.|set-inform http://ip-of-controller:8080/inform|
 |:::|The Set-Inform URL tells the Unifi Access Point where the controller is located. By default, the access point will search the network for the controller, using the default DNS name **unifi**. This does not always work, so we need to tell the access point the correct address of the Unifi Controller.|set-inform http://192.168.1.10:8080/inform|
+|syswrapper.sh|Similar to set-default.  Older firmware versions like v2.2.x do not support the **set-default** command.|syswrapper.sh restore-default.|
 |upgrade <firmware_url>|Upgrade firmware.|upgrade http://192.168.1.10/unifi_fw.bin|
 |uptime|Displays the device uptime.|uptime|