Differences

This shows you the differences between two versions of the page.

--- pfsense:use_expressvpn:configure_firewall [2020/04/18 22:10] – [Configure Firewall Rules] peter
+++ pfsense:use_expressvpn:configure_firewall [2020/11/30 14:42] (current) – removed peter
@@ Line 1: / Line 1: @@
-====== PFSense - Use ExpressVPN - Configure Firewall ======
-Now that the tunnel is online, you need to tell all of your traffic to be NAT’d properly.
-===== Configure NAT =====
-Navigate to **Firewall -> NAT -> Outbound**.
-  * Select **Manual Outbound NAT rule generation**.
-  * Press **Save**.
-Then multiple rules will appear.
-Against the rule **Auto created rule - LAN to WAN**, click on the icon on the right side that looks like two page (a square overlapping another square).
-{{:pfsense:use_expressvpn:pfsense_firewall_nat_outtbound_-_lan_to_wan.png?800|}}
-In the window that pops up:, the only selection you will be changing is the **Interface” section**.
-  * Interface:  Click the drop-down and change from **WAN** to the name of the Interface you created previously, in this case **VPN_WAN**.
-  * Click **Save**.
-{{:pfsense:use_expressvpn:pfsense_firewall_nat_outtbound_-_lan_to_wan_-_edit.png?800|}}
-  * Click **Apply Changes** at the top.
-----
-===== Configure Firewall Rules =====
-Create a rule to redirect all local traffic through the ExpressVPN gateway you previously created.
-Navigate to **Firewall > Rules**:
-Click on **LAN**.
-Click the **Add** button with the up arrow (the far left button).
-{{:pfsense:use_expressvpn:pfsense_firewall_rules_-_buttons_-_add_top.png?600|}}
-Enter the following:
-In **Edit Firewall Rule**:
-  * Action:  **Pass**.
-  * Disabled:  **Not Checked**.
-  * Interface:  **LAN**.
-  * Address:  **IPv4**.
-  * Protocol:  **Any**.
-In **Source**:
-  * Source:  Select **Single host or alias**; and type the name of the host or alias that should use the VPN.
-in **Destination**:
-  * Destination:  **any**.
-In **Extra Options**:
-  * Log:  **Not Checked**.
-  * Description:  Enter something meaningful to you.  For example **LAN TRAFFIC –> EXPRESSVPN**.
-Click the blue **Display Advanced** button.
-{{:pfsense:use_expressvpn:pfsense_firewall_rules_-_display_advanced.png?400|}}
-In **Advanced Options**:
-  * Gateway:  **VPN_WAN**.
-  * Leave everything else.
-  * Click **Save**.
-{{:pfsense:use_expressvpn:pfsense_firewall_rules_-_advanced_options_-_gateway.png?800|}}
-----
-===== Complete =====
-You are finished!
-You should now start to see traffic flowing through your new rule you created, confirming that the traffic is moving through the ExpressVPN tunnel you created.