Differences

This shows you the differences between two versions of the page.

--- pfsense:pfblockerng:install_pfblockerng [2021/01/28 10:45] – peter
+++ pfsense:pfblockerng:install_pfblockerng [2021/01/28 11:28] (current) – peter
@@ Line 9: / Line 9: @@
   * [[PFSense:pfBlockerNG:Install pfBlockerNG:Setup IP Blocking|Setup IP Blocking]]
   * [[PFSense:pfBlockerNG:Install pfBlockerNG:Setup DNSBL Blocking|Setup DNSBL Blocking]]
+  * [[PFSense:pfBlockerNG:Install pfBlockerNG:Update Blocking Lists|Update Blocking Lists]]
+  * [[PFSense:pfBlockerNG:Install pfBlockerNG:Test|Test]]
-----
 ----
-===== Update Lists =====
-Updates are run on the schedule earlier.
-However, the first one must be initiated manually to take effect immediately.
-Navigate to **Firewall -> pfBlockerNG -> Update**.
-Click the radio button for **Update** and click the **Run** button.
-Observe the log viewer as the update processes and allow it a couple minutes to finish.
-After the initial update, you should notice ads are now being blocked in your browser.
-{{:pfsense:pfblockerng:pfsense_pfblockerng_dnsbl_update_run_manually.png?800|}}
-----
-===== Check the Services =====
-Navigate to **Status -> Services**.
-Restart both **pfBlockerNG DNSBL** & **Unbound** services.
-{{:pfsense:pfblockerng:pfsense_services_-_pfblockerng.png?800|}}
-----
-===== Testing from the command line =====
-Normally, pinging a site will return the sites actual IP address.
-However, with pfBlockerNG properly setup you may instead see a reply of 10.10.10.1, which is the default virtual IP address DNSBL creates:
-{{:pfsense:pfblockerng:pfsense_pfblockerng_dnsbl_ping_block.png?800|}}
-For sites that are allowed to get through, their proper IP address will be returned by a ping instead of 10.10.10.1:
-{{:pfsense:pfblockerng:pfsense_pfblockerng_dnsbl_ping_not_blocked.png?800|}}
-The same goes for an nslookup query, which will also return a response of 10.10.10.1 for adverts:
-{{:pfsense:pfblockerng:pfsense_pfblockerng_dnsbl_nslookup_block.png?800|}}
-For sites that are allowed to get through, their proper IP address will be returned instead of 10.10.10.1.
-{{:pfsense:pfblockerng:pfsense_pfblockerng_dnsbl_nslookup_not_blocked.png?800|}}
-----