pfsense:install_pfsense:create_interfaces
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| pfsense:install_pfsense:create_interfaces [2020/12/16 12:16] – [PFSense - Install pfSense - Create Interfaces] peter | pfsense:install_pfsense:create_interfaces [2021/01/05 14:15] (current) – [Configure interface IP addresses] peter | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== PFSense - Install pfSense - Create Interfaces ====== | ====== PFSense - Install pfSense - Create Interfaces ====== | ||
| - | < | + | < |
| The approach taken here is to match the third octet of each interface IP address to the corresponding VLAN tag. | The approach taken here is to match the third octet of each interface IP address to the corresponding VLAN tag. | ||
| Line 56: | Line 56: | ||
| * MTU: **None**. | * MTU: **None**. | ||
| * MSS: **None**. | * MSS: **None**. | ||
| - | * Speed and Duplex: | + | * Speed and Duplex: |
| In **Static IPv4 configuration**: | In **Static IPv4 configuration**: | ||
| Line 89: | Line 89: | ||
| * MTU: **None**. | * MTU: **None**. | ||
| * MSS: **None**. | * MSS: **None**. | ||
| - | * Speed and Duplex: | + | * Speed and Duplex: |
| In **Static IPv4 configuration**: | In **Static IPv4 configuration**: | ||
| Line 122: | Line 122: | ||
| * MTU: **None**. | * MTU: **None**. | ||
| * MSS: **None**. | * MSS: **None**. | ||
| - | * Speed and Duplex: | + | * Speed and Duplex: |
| In **Static IPv4 configuration**: | In **Static IPv4 configuration**: | ||
| Line 135: | Line 135: | ||
| Click **Save** and Apply changes. | Click **Save** and Apply changes. | ||
| - | |||
| - | <WRAP center round todo 60%> | ||
| - | Update this picture to show 192.168.99.1/ | ||
| - | </ | ||
pfsense/install_pfsense/create_interfaces.1608120988.txt.gz · Last modified: 2020/12/16 12:16 by peter