Differences

This shows you the differences between two versions of the page.

--- pfsense:install_pfsense:create_interfaces [2020/12/11 10:07] – peter
+++ pfsense:install_pfsense:create_interfaces [2021/01/05 14:15] (current) – [Configure interface IP addresses] peter
@@ Line 1: / Line 1: @@
 ====== PFSense - Install pfSense - Create Interfaces ======
+<WRAP info>
+The approach taken here is to match the third octet of each interface IP address to the corresponding VLAN tag.
+This just makes it easier to remember:
+  * VLAN tag **50** => 192.168.**50**.0.
+  * VLAN tag **70** => 192.168.**70**.0.
+  * VLAN tag **99** => 192.168.**99**.0.
+</WRAP>
+----
 ===== Create an interface per VLAN =====
@@ Line 42: / Line 56: @@
   * MTU:  **None**.
   * MSS:  **None**.
-  * Speed and Duplex:  **Default (no preferences, typically autoselect)**.
+  * Speed and Duplex:  **Default (no preference, typically autoselect)**.
 In **Static IPv4 configuration**:
@@ Line 75: / Line 89: @@
   * MTU:  **None**.
   * MSS:  **None**.
-  * Speed and Duplex:  **Default (no preferences, typically autoselect)**.
+  * Speed and Duplex:  **Default (no preference, typically autoselect)**.
 In **Static IPv4 configuration**:
@@ Line 108: / Line 122: @@
   * MTU:  **None**.
   * MSS:  **None**.
-  * Speed and Duplex:  **Default (no preferences, typically autoselect)**.
+  * Speed and Duplex:  **Default (no preference, typically autoselect)**.
 In **Static IPv4 configuration**:
@@ Line 121: / Line 135: @@
 Click **Save** and Apply changes.
 {{:pfsense:install_pfsense:pfsense_-_interfaces_-_guest.png?800|}}